Lay the starter row of metal shingles at the drip edge and affix to the roof with metal roofing nails.
How to install metal roofing on steep roof.
Work up from the initial row starting at the lower corner in a diagonal pattern staggering the shingles to prevent gaps.
The eave flashing or edging is just the steel metal strips used to cover the entire perimeter of the roof.
For exposed fasteners avoid over tightening the fastener.
Use your neoprene washer head screws to secure the metal to the sheathing.
You can use 1 inch nails for the installation of eave flashing.
Arrange the shingles so the ends and the tab notches do not lie directly above gaps in the shingle below.
Make sure that the screws are all aligned evenly as you will be able to see them from the ground if they are.
Next you are ready to install the metal roof.
How to apply roofing to a steep roof.
If playback doesn t begin shortly try restarting your device.
Most metal shingles will be attached to the roof using metal shingle.
Install shingles from the lower left corner working to the right and also working up the roof slope.
Tips for working on steep metal roofs.
Working on any roof is dangerous and slick metal roofs with a steep pitch are particularly perilous.
If the gaps lined up water could get directly onto the roof sheathing and then seep in through a nail hole.
You are essentially sealing off the metal roof with this flashing and you need to make sure that is securely fastened.