How To Install Tongue And Groove Siding On Ceiling

For the next piece you will connect the groove of the new piece into the tongue of the first piece.

How to install tongue and groove siding on ceiling.

And use existing studs rafters to mount each piece of paneling. Cut your first board to length and nail in place with the groove facing the wall and the tongue facing out. Then with a scrap piece of tongue and groove stock as a block give the board a firm tap. If you re installing tongue and groove boards over drywall or plaster especially it s a good idea to install 1x2 battens and fasten them directly to the framing with 2 1 2 in.

Nail close to the wall on the groove side crown mould will hide this nail and on the v groove part of the tongue side. Use the framing gun to add a nail to the tongue of the plank and secure in place. Measure the ceiling s width and length to ensure you get the proper size board for the tongue and groove ceiling. The process here is almost exactly the same.

Nail on the tongues cut and position the next board. Set a board in place. Installing a tongue and groove ceiling. Groove facing the wall tongue facing out.

Divide the width of the ceiling by the surface width of each board not including the protruding tongue so that you can estimate the width in planks of your ceiling. Once you ve installed your tongue and groove wall paneling you can move on to the ceiling. Use a scrap piece of wood with a groove cut it in that fits over the tongue or a scrap piece of ceiling material and fit that over the board before tapping gently with a hammer. You ll start from one corner.

Here s a way to install a tongue and groove ceiling without damaging the wood.