Begin installing the material upward from the starter strip overlapping the edges of the siding by about 1 inch.
How to install vinyl siding over metal siding on a mobile home.
To install the furring strips start by cutting them to size so they run from one end of the surface to the other.
Typically aluminum is not used anymore to reside residential homes so the siding needed to be special ordered.
Putting up furring strips will help even out the surface you re working on so the metal siding doesn t look wavy.
Then slide the tool along the piece of loose vinyl siding.
Lay the siding starter strip on the chalk line and hammer in a nail about every 10 inches.
Could there be any issues with using the vinyl over the old metal siding.
Obtain a vinyl siding tool.
If so do you have to take the metal off first.
Step by step instructions step 1.
You will get a better final result the metal siding provides minimal insulation value and the metal whether it is aluminum steel or other can be recycled at a local scrap yard for.
The home was re sided with vinyl over top of the metal.
Continue with each subsequent piece of siding until the mobile home is complete.
Central florida 1978 mobile home with vertical metal ribbed siding.
Remove the metal siding.
Do you have to put something like osb or insulation board under the vinyl or the vinyl just goes on the top of the metal.
Cut the first piece of siding and install it over the starter strip.
I would like to know if any one here has ever put vinyl siding over metal siding on a mobile home.
The client had a tight budget and just wanted to patch in new siding to match the existing siding.
Make sure there s a gap of about one eighth of an inch with each piece of siding to allow for overlap.
Some of the siding may need to be cut with a table saw to properly fit and overlap the adjoining pieces.
Hook your tool underneath the siding and pull down to start.
Aluminum siding installed on this particular job the home already had aluminum siding.
Slip the ends of the siding under the installed fittings.
Finish with a tap of the hand to tighten.