Locate the lowest possible corner that has sheathing.
How to install vinyl siding starter strip.
This is where the new siding will begin.
It protects the sheathing from rain snow and pests.
Nail in the center of the starter strip nailing slots.
This video shows how to install a starter strip for vinyl and polymer siding installation.
Using the chalkline as a guide install the top edge of the starter strip along the chalkline nailing at 10 254mm.
Hold a tape measure against the exterior wall and travel.
This chalk line should be level and a consistent distance from the eaves or the top and bottom of the windows.
Snap a level chalk line for the first starter strip at the base of the wall no less than 8 inches above ground level after determining the lowest corner of the house.
Measure a spot that is 1 1 2 inches above the bottom edge of the sheathing at this lowest point using a tape.
Below the top of the foundation but the lower the vinyl siding is installed the better.
How to install a vinyl siding starter strip step 1.
Find the lowest corner of the old siding or sheathing on the house.
Use the wider starter strip the bottom of the starter strip the part the bottom panel hooks on to should be at least 1 in.
3 install the corner posts.
Attach the starter strip to the plywood but don t nail it so tightly that it will restrict the strip s movement.
Keep the ends of starter strips at least 1 4 6 4mm apart to allow for expansion fig.
Vinyl siding starter strips.
Quality products can only perform well if they are installed properly.
When correctly installed certified vinyl siding will al.
Installing inside corner.
Position starter strip with the top edge of chalk line and allow room for corner posts.
Vinyl siding is no exception.
Insulation for vinyl siding 1.
Partly drive a nail 11 2 in.