How To Install Wired Window Alarm Sensors

Wired window alarm sensors work with something called a reed switch contact and a magnet.

How to install wired window alarm sensors.

A hole must be drilled for the diameter of the recessed contact into the window frame. If not you can buy it at any electronics store or home improvement center. A recessed wired window sensor is installed in the frame of the window and the magnet is installed in the window frame directly across from the contact. The connection wire usually comes with a window sensor kit.

Most door contacts function using a sensor and a magnet. Mount the new sensor. Make sure that the wires are nice and secure and won t easily come loose. Most of the time it s not complicated and there s always the option of choosing a home security company that will do the installation for the homeowner.

Ideally you should have no problems installing a sensor onto a single hung window. But installing a window sensor isn t always the easiest it depends on the make and model of the sensor and what the homeowner is looking for. Recessed hardwire contacts advantages. Plug the connection wire into a sensor.

The switch and magnet are two separate parts. Most door contacts need to be within a half inch of the magnet when the door is closed for proper operation. Then mount the magnet on the moving part of the door as close to the sensor as possible. How window door sensors work.

That said you may find an issue depending on your trim choices. The place where you should install a sensor contact on a door is on the stationary frame. Install the switch into a hole drilled into the outer door or window frame making wiring connections first. Simply install them along the top casing head jamb or along the side casing side jamb.

Install the magnet in a hole drilled into the moving frame. Use a screwdriver to connect the existing wires to the new door sensor. Please see the instruction manual for your sensors if you need further assistance. Apply the new sensor to the door frame.

Run a two conductor wire for the control panel to the hole which was just drilled. The reed switch attaches to the window frame and the magnet to the pane. Single hung windows are almost ideally configured for alarm sensors. Run the wire to your control panel either along a corner of your wall or through the wall if you are able.

Best options for installation.