Allow the primer to dry.
How to paint latex over old varnished siding.
Paint adheres well over water based stain so after completing the prep steps outlined above apply a water based latex primer with a brush or a roller.
One bottle of oil bond treats two gallons of latex based paint.
Prime all the surfaces using the bonding primer and a paint brush.
Start by cutting the edges of the trim and then paint the flat surfaces.
Painting over varnish with latex.
To ensure the best results ask your paint.
Several points how to correctly paint over aged painted clapboard wood siding will have lasting quality protection.
Cover the floors with drop cloths.
It also helps the finish paint cover with fewer coats.
Wipe off the dust with a brush.
Painting over faded peeling outside paint special attention must be given.
This is especially true when painting over stained and varnished trim.
Two methods enable varnished surfaces to accept.
Then repeat this process with the latex paint.
Apply 2 3 coats allowing each coat to dry before applying the next one.
Sand and scuff the entire surface you will be painting using a medium grit sanding block.
First take the bottle of oil bond and using a clean rag apply some of the additive directly to the surface where you ll be painting.
How to paint over old exterior paint correctly.
If you plan to use a latex based paint then use a water based latex primer.
Most paint jobs can be handled with a three inch straight edge siding brush a two inch angled sash brush and a two and a half inch straight edge trim brush.
If you plan to use an oil based paint to cover your wood use an oil based primer.
Oil based primers can take up to 24 hours while latex based primers typically dry in up to 4 hours.
Have the home center or paint store tint the primer to a grayish color to help cover the underlying varnish.
Then roll on a coat of bin or kilz available at home centers for about 8 per quart.
Then add oil bond directly to your paint using a clean bucket.
Are you getting ready painting over old exterior paint.
Rough surfaces like stucco will take more paint so use 200 square feet gallon for this type surface.
Do not sand down.
In all paint projects the finish is only as good as the surface preparation.
Let the primer dry as directed.
Prepare a cleaning solution of trisodium phosphate tsp and hot water according to the manufacturer s.