How To Remove A Strip Of Vinyl Siding

Ask this old house general contractor tom silva helps a homeowner repair sections of his vinyl siding that have holes.

How to remove a strip of vinyl siding.

Pull the zip tool down while simultaneously running it all the way across the lip of the vinyl siding panel to unlock or unzip the bottom most panel from the starter strip. Look for a horizontal seam between two courses of vinyl siding. Then unzip any pieces above the damaged piece. To remove the uppermost piece start at one end of the bottom of the first panel and push the end of the zip tool up under siding until it hooks onto the underside of the lip.

Installing a replacement piece of vinyl siding is the reverse of removing the damaged panel. Slide the zip tool along the bottom edge to release the vinyl siding from the piece below it. If it is use it to remove the paint. But first test it out on a small spot on the panel and leave it on for a short while to make sure that it is safe for vinyl.

Rub the paste onto the paint stain and leave on for a few minutes before using a soft rag to scrub it off gently. If it remains stuck double check to see if. First you nail up the new piece driving nails through the slots in the nail hem then you connect the buttlocks with the zip tool. Pull the zip tool downward and out to unhook the bottom lip then slide it along the edge pulling the siding out as you go.

Insert the siding removal tool where the panels overlap and pull down and out. Here are the basic steps. If the siding is hard to remove try tapping it with the palm of your hand. If the piece still seems attached to the wall gently pull it outward so it comes free of the channel holding it in.

Subscribe to this old house. The vinyl siding zip tool will save you loads of time. Pull the piece of vinyl siding. Use the zip tool to release the buttlock at the top and bottom of the piece you want to remove.

The loose bottom of the.