How To Replace A Piece Of Aluminum Siding

How to replace aluminum siding panels 1 using tin snips make a vertical cut at each end of the damaged piece.

How to replace a piece of aluminum siding.

Cut out damaged area. If in doubt place a nail every 4 inches minimum. Tap with a hammer to indent the damaged area or use tin snips or a utility knife to cut it out. The tools required for aluminum siding repair will depend mainly on the type of project you are doing.

Your first piece will lock into the starter strip at its bottom edge the top of the first piece has a nailing band that should be held down with aluminum roofing siding nails. You will use the utility knife to cut or score two vertical lines on either side of the damaged part of the siding. Work fast because this stuff sets up quick. Make it 3 inches wider than the patch you removed so.

Follow the siding manufacturer s guidelines for nail placement. Draw a square around the damaged siding. Install your starter strip drip edge at the bottom of the wall and allow it to extend past the area where the foundation meets the sill plate by at least an inch. Repair loose aluminum siding storms accidents and a variety of weather can cause interlocking aluminum siding to become loose.

Use caution when working on ladders. Aluminum siding is installed in an interlocking pattern where the upper edge of each piece has a flange for nails which. Repairing loose siding panels for example is simply a matter of using a siding unlock tool but more complex projects such as replacing damaged or missing panels will involve many more tools including a circular saw. Cut the replacement patch.

Peel off any excess so the patch is flush with the front of the aluminum siding. Remember that with aluminum siding you can replace sections. 2 leave the nailed upper section in place and remove the lower half. Bend the square down and then cut across the bottom.

3 cut the nailing tab off the top of the replacement piece. Locate the area of your aluminum siding that is damaged. They may appear slanted and make your house unattractive and these loose pieces make a flapping sound on windy days that can make a sound inside and outside your home. With a utility knife cut the top and side edges.

If you cannot cut through the aluminum with a utility knife and strength you can use a screwdriver and hammer to get the line started. Mix the two components together thoroughly then push the putty into the hole with your fingertip.