If possible leave at least 2 inches of siding along the top edge of the damaged piece.
How to replace a small piece of vinyl siding.
If the siding is still in good condition lay a tarp our to keep the siding clean.
Use a zipper tool to remove the cutout.
Designate a large area to pile the pieces of vinyl siding.
Look under the siding piece you just located for a short flat notch.
Locate the vinyl siding piece above the piece you need to replace.
Ask this old house general contractor tom silva helps a homeowner repair sections of his vinyl siding that have holes.
Use a utility knife to cut around the damaged area.
Wiggle the hook into the curved bottom lip of.
Slide the replacement piece up into place pushing up until the lower lip locks into the piece below it.
It ll better match the house than brand new siding.
With the other use the claw.
Slip the hook of the zip tool into the joint between the damaged piece and the piece above it.
Insert the tip of the zip tool into the.
Hold the loose undamaged piece of vinyl up and out of the way with one hand.
Use framing square and utility knife to cut through face of siding.
Go to the end of that row either near a corner piece or a j channel.
If you are going to throw it away or recycle it park a truck nearby so you can throw the siding directly into it for removal from your property.
Cut piece of faded siding from an inconspicuous spot to replace the damaged section.
Roofing nails through the nailing flange.
Subscribe to this old house.