However sometimes things just don t go as expected.
How to replace the springs on pull down attic stairs.
If pull down attic stairs have already been installed or you have taken the time to.
Then unscrew the spring on the attic floor joist.
General contractors and carpenters install attic ladders or stairs.
Pull down attic stairs have coil springs attached to the power arms at each side of the unit that keep the door closed and even with the ceiling.
Clean around the area where the new spring will be fitted and then bring up the new spring.
Who installs attic ladders.
Using a reciprocating saw cut off the metal hinges of the staircase.
They need to be licensed and insured before starting work for you.
Be sure to check reviews and credentials before you hire someone.
Remove the springs from the old attic staircase by bending the metal arms forward to release the tension.
Grab the loose end of the spring with a pair of pliers.
By pulling down on a string the trap door opens revealing a fold up ladder held in place by springs and hardware.
Pull toward either end of the spring.
November 29 2017 diy repairs can be fun and cost effective.
Measure the rough opening of the attic staircase and match it to find a suitable replacement.
Often times the unit can be repaired rather than replaced.
If a spring has come loose at one end climb the stairs enter the attic and have an assistant close the stairs.
Also cut off the nails that hold the staircase to the structure opening.
Put on your work gloves and grab one of the springs in the middle.
Common problems with pull down stairs.
If you are replacing the attic stairs unscrew the springs.
Brought down to the floor accessing the attic crawl space is simply a matter of climbing the ladder.
While pulling have your partner use the screwdriver to gently pull the hooked end of the spring out of the ring it is attached to.
In this video i show how a 15 mins hardw.
Changing out the entire attic stair unit can be potentially very difficult to do for homeowners.
Do this by removing the screws from the ladder side first and then folding the spring back so that it is level and not about to snap down.