How To Shorten Gutters

Measure the distance between these fittings and cut a short length of downspout to join the allowing for about 1 1 2 in.

How to shorten gutters.

When installing gutters set the proper slope by driving a nail 1 2 in. Below the shingles on the high side of the gutter run. Place the length of aluminum gutter flat on the worktable with the top of the aluminum gutter resting on the. Use the old adage measure twice and cut once then turn the gutter upside down on the table and mark it all the way around.

Mark the cut length onto the bottom of the aluminum gutter which should be facing up with the tape measure and. One way to make sure your gutter doesn t fall off the house is to install fascia hanger brackets. How to cut and install a gutter outlet. Measure and record the distance from the bottom of the fascia board to this nail.

Hold the gutter firmly against the fence of the table the short wall at the back of the table that makes it possible to cut straight lines. Then hold a second elbow against the corner of the house in line with the first elbow. Start by pushing the female end of a downspout elbow onto the first outlet fitting. For every 10 feet of gutter from this measurement and mark this distance at the low end of the gutter run.

Remove the elbow from the end of the downspout. Step 4 adjust the angle of the saw if the gutter goes on a corner. Buy a length of plastic corrigated drain hose and a downspout adapter and stick it on the end of the downspout. Use a carpenter s square to get around to the bottom.

How to cut aluminum gutters step 1. How to cut metal gutters step 1. Leave the old spikes in place a spike head looks better than a hole in the gutter. Pull the tape measure along the length of metal gutter and mark the length you need to cut the gutter with the.

Place the gutter on the miter saw table. Of insertion on one end. Rest the base of the carpenter s square against the top edge of the metal gutter and align the blade of the. Using a fine 24 or 32 tooth per inch blade in a hacksaw cut off what you need.

Extend the cut mark.