How To Slope Rain Gutters

How to check a gutter s slope.

How to slope rain gutters.

To ensure that gutters drain properly make certain they slope inch for every 10 feet toward a downspout. Rain gutters have to slope down to the downspout for proper drainage. This gutter looks to be over 1 inch per 10 feet. Gutters need to be pitched toward the downspouts for the water to flow properly.

Measure the length of the string to determine the distance between the two points. Use a string level to ensure the string is completely parallel to the ground. This means that your gutter should be a half inch lower in height at every 10 foot mark until you reach the downspout. You want at least a quarter inch of slope for every 10 feet.

The standard slope for rain gutters is half of an inch for every 10 feet. For spans longer than 40 feet it s wise to have a downspout on each end and start the high spot of the gutter in the center. Or you can slope the gutters down from each end toward a single downspout placed in the middle of the run. Gutter sloping only needs to be 1 4 inch per 10 feet.

A line spirit level is a very small level that attaches to string. To calculate gutter slope attach one end of a long piece of string to the highest point of your gutter and the other end at the location of your downspout. To correct this yourself you ll need to measure from the peak to the downspout. For gutter runs longer than 40 feet it s best to pitch the gutter down from the middle to a downspout at each end.

Get on a ladder after a rainstorm and look in the gutter. It should run at a consistent speed down the gutter to the downspout. Pull the line tight to the other side of where the gutters will be installed. The gutter should have a quarter inch of slope per 10 feet.

It s sloped so much the flashing or drip edge is no longer covering the back of the gutter. Once the gutter is properly pitched re install the gutter brackets. If there s standing water it s not pitched properly. Place the line spirit level on the string.

Put a temporary screw at the back to adjust the pitch. Pull the gutter down about 3 quarters of an inch lower than it originally was.