How To Tie In Standing Seam Roof With Asphalt Roof

The difference would be from the transition flashing up the asphalt shingle roof instead of metal roof.

How to tie in standing seam roof with asphalt roof.

Hook that side lock to the drip edge and fold in down with your fingers. In a standing seam roof long single panels run vertically all the way from the eave to the ridge. It was then easily tapped back into position. Better steel shingle systems like the one shown install over a framework of 2x2s.

In a standing seam roof long single panels run vertically all the way from the eave to the ridge. A metal shingle roof could cost between 8 00 and 13 00 per square foot installed while a standing seam metal roof may be 10 00 to 16 00 per square foot installed. In contrast steel shingles are small panels installed in horizontal rows much like other shingles. Once we had split the seams on both sides we found each panel was held to the roof with 3 clips on one side of its 15 length.

In some situations you will be required or may choose to use a drip edge as gable trim. In that case instead of bending up 1 inch of fake lock bend down about 7 8 lock to a 90 degree angle. We then secured each. Use hand seamer to tightly crimp the lock.

In a standing seam roof long single panels run vertically all the way from the eave to the ridge. In contrast steel shingles are small panels installed in horizontal rows much like other shingles. How complex is the installation. The transition flashing down would be the.