But these newer cab lights.
How to wire 4x4 roof lights.
Connect the wire from your switch to the power wires on your lights.
Am i right in thinking that its best to wire the four in parallel through a relay switched independent of the headlight controls in the cab as i dont want them for road.
Its an sle that came well optioned but did not include the led cab roof light package.
I will use a dedicated positive and negative wire for 3 circuits.
Use tape to hold the cable until the glue dries.
I understand the older trucks had round holes under the lights which are easy to drill and install.
There will be an unused wire.
With the mounting brackets bolted into place you can tighten the end brackets into place and aim your lights to point perpendicular to the front of your 4wd then plug your lights into your wiring harness.
The contacts are rated at 25a which is more that enough for each of the circuits going to my roof rack.
There are numerous ways to run the cabling or wiring from the roof back down to engine bay and listed below in order of preference is how most professionals be it 4x4 shops or auto electricians will complete the install.
Run the single red wire down the a pillar of the passenger side.
Scotch lock the rest of the lights to the red wire.
Slide each end in a crimp style wiring connector.
One circuit for the cigarette lighter accessory socket going to the roof top tent.
Run the wiring and tape it to the cab roof.
If your lights do not have connectors included strip a half inch of bare wire from the end of each power wire using your wire strippers.
Use the crimpable wire connector to connect the driver side cab light wire to the red wire.
One circuit for the led light bar.
Run the red 16 gauge wire from driver side to passenger side.
One circuit for the led flood lights.
Refit the tail lamp glue the cable into position with small dabs of clear silicone.
Hi all i have just bought myself four spot beam led roof bar lights for my 90 and was hoping for some advice as to wiring them.
Hello all im new to the forum and recently purchased a 2017 sierra 2500 crew cab.
Cut a small hole in the rubber grommet for the cable and refit the grommet.
Once the glue is dry remove the tape.
Running wiring from the roof is generally not a plug and play affair and will require some auto electrical knowledge in.