The stales are installed every 12 into the tongue of the board and are covered and hidden by the next boards groove is installed.
How to nail tongue and groove cedar siding.
Tongue groove installation tongue and groove siding can be installed horizontally or vertically.
Nails should penetrate 1 1 4 inch into solid wood behind the siding.
We used 1 1 4 long 1 4 galvanized staples to install this cedar.
With tongue and groove paneling the nails are inserted into the groove and hammered to below the surface.
Tongue and groove or lapped sidings generally have a rustic cabinlike appearance.
Other types of nails will leave stains on your siding.
Because the overlap is less than on other types of siding these provide somewhat less protection from the elements.
The tongue section of the board should be at the top with the groove section at the bottom.
A variety of siding types fit together by means of tongues and grooves or over and underlapping edges.
Drive the nails through the shoulder of the tongues into the framing at about a 45 degree angle.
To ensure that the nail gets into the groove where it will be hidden it must be inserted at an angle.
Just make sure the nail is flush with the tongue so the next groove can fit.
This is part 1 of a 3 part series.
Nail gun for tongue and groove siding tools equipment tongue and groove siding t g patterns pictures why adirondack is back woodhaven tongue and groove siding t g patterns pictures vertical tongue and groove siding exterior modern with tongue and groove siding protect your colorado home.
Siding up to 6 inches wide can be blind nailed with one siding nail per bearing toe nailed through the base of each tongue.
In horizontal application start at the bottom and work up with the groove edges facing downwards.
One of the cool things about tongue and groove walls is that you can use a technique called blind nailing if you do it properly you won t have any nail heads showing or holes to fill.
Then on the last board you will need to nail through the board but you can paint the nails when you re done.
How to install tongue and groove siding.
If the nail is too short it won t hold the pine tongue and groove securely to the ceiling.
The nail must be long enough to go through the piece of pine and into the ceiling above.
If installing one half inch pine use 1 1 2 inch nails.
The length of the nails is more important than the gauge when using the nails to install tongue and groove wood.
Because the nail goes in at an angle and needs to be sunk a nail gun is a better option than a hammer.
The next grooved edge will hide the nail holes.
Nails can be spaced up the board about two feet apart and they do need to be stainless steel.
Should the framing be covered by sheetrock plywood or house wrap before beginning installation snap a chalklike or mark a line over the covering to ensure you nail at least 1 1 4 into the framing each and every time during installation.