Here s how to go about it.
How to patch roof using a tarp.
Installing a tarp on your roof is easier than you think.
Lay more 2 by 4s on either side of the tarp and attach those as well for a tight well secured water barrier.
Try to pick a day that is not windy or else you may face frustration because as soon as you open the tarp up there it will start blowing all over the place.
Extend the top edge of the tarp over the ridge of the roof.
Secure the tarp to your roof.
Create an anchor board by rolling the tarp s peak end with a 2 x 4 inch board and nailing the tarp to your board with.
The 2 by 4 should be about 2 feet longer than the tarp width.
Here are the steps on how to install a tarp on your roof without nails.
Sandwich the tarp by nailing a second 2 x 4 board to.
To secure a tarp to your roof.
Remember never walk on the tarp as it can be easy to slip.
Pull away from each other until the tarp is fully unrolled.
Then fold the excess tarp under a few rotations for a tight clean fit.
Stretch a tarp flat on the roof.
Grab one corner of the tarp and have a helper grab the other end.
You need to know first which spot on the roof needs tarping up.
If you have a ladder a knife a cordless drill saw you are all set just need to pick up some supplies a tarp that.
Partially unroll your tarp to cover the damaged area from the roof s eaves to peak.
After this step you ll want to sandwich the tarp between another 2x4 and temporarily secure the bottom 2x4 to the roof with a nail.
Find the source of the roof leak.
If you have a helper this part is easy.
Lay the tarp flatly over the damaged area and make sure there are at least 4 feet of it overhanging past the roof s peak and the rest over the eave.
If you don t have a helper use the metal rings to hold down the tarp at the furthest four corners.
To minimize water damage in the interim before long term repairs can be made cover the damaged part of the roof with a tarpaulin.
A tarp that will at least extend past the damaged area by at least 3 on each side the bottom the ridge the thicker.
Screw the 2 by 4 directly into the roof to secure it.
The thicker the tarp is the better if it has uv.
Things you ll need tape measure brush tarp 4 2x4 38 x 89 mm boards cap nails carpenter s gloves drill 2 inches 5 1 cm screws.
Roll the tarp s edges using 2x4 s to secure the wood and nail it to the tarp using 3 inch nails.
It s even easier if you do it without nails.
Find the source of the leak.