How To Tie Shed Roof Into Metal Building

Place the t strap upside down so the two holes are at least 1 below the top of the concrete slab.

How to tie shed roof into metal building.

Expose the concrete at both ends of each skid. 6 x5 t straps are light 14 gauge galvanized steel and weigh about 4 ounces each. How to attach a lean to to an existing metal building. Below is a general outline of how to do such an addition.

T straps are another way to anchor a shed built on skids to a concrete pad. Remove siding from the house where the new roof will attach to expose rafters or other framing of the old roof. We need to do something where that change happens so the panels can go down and water can come off hit the lower slope and come off the roof. If your home improvement plans include tying in a shed roof addition you best know how to accomplish this task first.

Step 1 location location location. Determine where the lean to will be attached to the existing building. Then caulk the nail heads. We re going to do a pitch transition or change.

You ll have a steeper part of your roof turning into a lower slope so there s a steeper pitch up top and a lower pitch on the bottom. Cut the 6 inch thick lumber into blocks that run the length of the lean to. If the house is sided with shingles or lap siding simply slip the metal s top edge up under the bottom edge of the shingles or siding as far as possible. Connect a flat roof to a sloped or pitched roof with a ledger board.

This latest project was in early december in lambeth ontario for a residential home that had an existing sloped or shingled roof that needed to tie into a ne. The preferred spot would place the lean to under the overhanging.